It makes it easy to separate molds and shaped products, while ensuring a good surface quality. Does not cause stains on concrete elements. Application area Form Oil can be used for greasing all forms: steel, aluminum, wooden, plastic, etc., in the manufacture of reinforced concrete products, foam blocks, gas blocks, colored concrete, asbestos-cement roofing tiles, shaped concrete and fireproof products, formwork lubrication. The most economical way of application is spraying, but at the same time it can be applied with a brush. The thinner layer of the applied film - the better! Grease Form Oil can be applied to a warm (80-90 ° C) mold. Packing and transportation Supplied in non-returnable steel barrels of 216.5 liters and 50 liters of plastic cans. Specifications and tolerances ISO-L-B. Instructions for use and storage When using, storing and transporting Form Oil you should observe the safety regulations and environmental requirements for petroleum products. Flammability class: III. Grease consumption: 1 liter per 50-80 m2 (depending on the method of application). When sprayed with a real, proven flow rate of 1 liter at 74-75 m2 Benefits of Form Oil in front of other lubricants - used on all types of molds; - does not require additional preparation before use; - Economical consumption; - It is possible to use it in open facilities under any weather conditions (at t up to -30 ° C); - Easy application to molds; - Creates a quality, smooth and uncontaminated surface of the product; - Absence of a specific odor; - Manufactured products are easy to plaster and processing.